Training steps and methods The first stage of the training is to establish the conditioned reflex of the command and gesture. The method to train the dog to sit frontally is: the trainer holds the leash with his left hand, guides the dog to the opposite side of him, makes a gesture with his right hand, and then issues the command, and at the same time Lift the leash with your left hand to force the dog to sit down. When the dog sits down, reward it immediately. After repeated training in this way, the dog can form a conditioned reflex to sit in front of the command. The second stage is to train the persistence of the dog's sit-and-wait delay. The third stage is training with complicated environmental conditions. When the dog can successfully obey the command and make actions in a quiet environment, the training environment can be gradually complicated to train the dog to strengthen its resistance. Interference ability. In the case of complex environmental conditions, the dog's movements are easily affected by external factors. Therefore, forced methods should be used appropriately to make the dog adapt gradually. Pet.com reminds you of issues to pay attention to when training dogs: (1) Pressing the waist corner must be accurate to achieve training effects. (2) Correcting the dog's automatic release of delay should be timely, preferably when the dog is about to move but is not completely destroyed. At the same time, the amount of stimulation should also be appropriately strong. (3) For dogs with high excitability, be patient when training the sit-and-wait delay. Don’t ask for too much each time, and don’t make the improvement too large.